MacroFire v2.4.1 Released For PSP
The MacroFire enables PSP gamers to remap buttons and turn them into rapid fire change deadzone on NUP. It can adjust the analog nub’s sensitivity and record and playback button macros. This version has just been recently released for the PSP.
To install the MacroFire, here are the instructions from zzxxzzxx:
01. Download MacroFire v2.4.1
02. Unzip To Anywhere (Eg. Desktop)
03. Turn On PSP
04. a. Connects PSP TO PC VIA USB Cable
b. Use Card Reader To Access Memory Card
05. Go To Root Of Memory Card
06. Opens SEPLUGINS Folder (ms0:\SEPLUGINS\)
(Create Folder If It’s Not There)
07. Create (1) POPS.txt, (2) GAME.txt, (3) VSH.txt If It’s Not There
08. Open & Add ms0:/seplugins/macrofire241/macrofire.prx In All 3 *.txt
09. Copy “macrofire.prx” & “macrofire.ini” From Your Unzipped Folder And Paste It In SEPLUGINS Folder (ms0:\SEPLUGINS\macrofire.prx & ms0:\SEPLUGINS\macrofire.ini)
10. Exit USB Mode & Unplug USB (Or Insert Memory Card To PSP)
11. Hard Off your PSP (Slide & Hold Off Switch For About 3 Seconds)
12. While Holding Down R Trigger, Turn On Your PSP (You’ll Enter CFW Recovery Mode)
13. Scroll Down To Plugins And Enter
14. You Should See 3 (Or More) Lines:
macrofire.prx[vsh]
macrofire.prx[game]
macrofire.prx[pops]
15. Enable All 3 By Pressing “X” While Beside Them
16. Select “Go Back”, Then “Exit”
17. PSP Will Start Up Normally
To start the application, simply enter a game and after loading completes, press “-“ and “+” for volume. This process would automatically enter the MacroFire Start Menu.
Download MacroFire v2.4.1
Tags: download, homebrew application, psp